Skip to main content

16.2 Machine Guarding

Common machine hazards occurring around moving parts include:

Pinch Points

Where two parts move together and at least one of the parts moves in a circle; also called mesh points, run-on points, and entry points. Examples include: Belt drives, chain drives, gear drives, and feed rolls.When shields cannot be provided, operators must avoid contact with hands or clothing in pinch point areas. Never attempt to service or unclog a machine while it is operating or the engine is running. 

Wrap Points

Any exposed component that rotates.Examples include: Rotating shafts such as a PTO shaft or shafts that protrude beyond bearings or sprockets. Watch components on rotating shafts, such as couplers, universal joints, keys, keyways, pins, or other fastening devices. Splined, square, and hexagon-shaped shafts are usually more dangerous than round shafts because the edges tend to grab fingers or clothing more easily than a round shaft, but round shafts may not be smooth and can also grab quickly. Once a finger, thread, article of clothing, or hair is caught it begins to wrap; pulling only causes the wrap to become tighter. 

Shear Points

Where the edges of two moving parts move across one another or where a single sharp part moves with enough speed or force to cut soft material.Remember that crop cutting devices cannot be totally guarded to keep hands and feet out and still perform their intended function.  Recognize the potential hazards of cutting and shear points on implements and equipment that are not designed to cut or shear.  Guarding may not be feasible for these hazards.

Crush Points

Points that occur between two objects moving toward each other or one object moving toward a stationary object. Never stand between two objects moving toward one another. Use adequate blocking or lock-out devices when working under equipment. 

Pull-In Points

Points where objects are pulled into equipment, usually for some type of processing. Machines are faster and stronger than people. Never attempt to hand-feed materials into moving feed rollers. Always stop the equipment before attempting to remove an item that has plugged a roller or that has become wrapped around a rotating shaft. Remember that guards cannot be provided for all situations - equipment must be able to function in the capacity for which it is designed. Freewheeling parts, rotating or moving parts that continue to move after the power is shut off are particularly dangerous because time delays are necessary before service can begin. Allow sufficient time for freewheeling parts to stop moving. Stay alert! Listen and Watch for Motion! 

Thrown Objects

Any object that can become airborne because of moving parts. Keep shields in place to reduce the potential for thrown objects. Wear protective gear such as goggles to reduce the risk of personal injury if you cannot prevent particles from being thrown. All guards, shields or access doors must be in place when equipment is operating. Electrically powered equipment must have a lock-out control on the switch or an electrical switch, mechanical clutch or other positive shut-off device mounted directly on the equipment. Circuit interruption devices on an electric motor, such as circuit breakers or overload protection, must require manual reset to restart the motor.